SKU: SKU: CMBCAM-310279
When lifting your vehicle, the stock upper arms become the limiting factor and hold back your suspension's performance. Our Camburg upper arms address these issues and more. Replacing the stock ball-joint with a larger 1.25 uniball bearing we can gain wheel travel with a part that is considerably stronger and will last longer under extreme conditions. We build more caster and change the camber curve to correct geometry, so the vehicle aligns correctly and improves driving characteristics and handling. Using the latest CAD/CAM engineering software we design these arms to the strictest standards using our FARO laser scan arm to model the OEM parts and frames. Manufactured in-house, we have the tubes CNC laser cut and bent, then are MIG welded in precision fixtures before sending out to be sandblasted and powder coated. Our in-house CNC machine shop makes all the machined parts, including the uniball mis-alignment spacers from heat-treated stainless steel. We pride ourselves in producing the best parts available under our own roof and control. When lifting your vehicle, the stock upper arms become the limiting factor and hold back your suspension's performance. Our Camburg upper arms address these issues and more. We build more caster and change the camber curve to correct geometry, so the vehicle aligns correctly and improves driving characteristics and handling. We replace the stock ball-joint with our new Camburg X-joint XL for increased strength, longevity and high misalignment, allowing for maximum wheel travel. The larger X-Joint XL is an extreme performance, all-weather, all conditions, high angle ball joint. These are much higher quality, considerably stronger and have an improved boot design that allows for higher angle use, better greasing and increased longevity. With higher strength heat-treated chromoly materials and an improved design, we were able to vastly improve upon what was available on the market. These fully sealed and greaseable joints are perfect for extreme conditions, so dirt, sand, rain, mud and snow are no match for them. Manufactured in-house, we have the tubes CNC laser cut and bent, then are MIG welded in precision fixtures before sending out to be sandblasted and powder coated. Step by step instructions with all the necessary hardware ensure a successful installation for your next off-road adventure.